Swann H.264 User Manual download pdf (Page 9)

7

Layout of the Rear Panel

1) CH1 ~ CH8 (Video Inputs): These

are the eight camera inputs, labelled as

per their channel in the DVR’s interface.

Thus, plug the camera you want to be

associated with Channel 1 into the port

marked CH1 and so on.

2) Video Outputs: This sends a

composite video signal out of the DVR.

Each of the two ports can be connected

to separate monitors. The output

marked MAIN will show the main

DVR interface (all channels accessible

plus menus, unless you’ve conﬁgured

the DVR to use the VGA as the main

output).

3) Audio Inputs (CH1 ~ CH4): Four

labelled audio inputs. These will accept

standard line-level signals (<1V) and

can be assigned to channels later.

4) Audio Output: Two mono audio

output channels. These output a

standard ‘line-level’ signal, and can

easily be connected to the audio inputs

on a television or stand-alone audio

device.

5) VGA Output: For connection to a

VGA monitor. This will display the same

image as the MAIN video output at a

selectable resolution between 800 x

600, to a maximum of 1440 x 900.

6 Above) USB Mouse Port: For

connecting the included USB mouse

(other standard USB mice will also

work). This port will not accept a USB

ﬂash drive – this port will work with a

mouse only.

6 Below) USB Backup Port: For

connecting a USB ﬂash drive for the

purposes of backing up footage.

7) RS485 Connections: This is the serial

communication port, used primarily to

connect PTZ (pan, tilt, zoom) devices.

8) Power Connection: For supplying

power to the DVR. Use only the supplied

power adaptor, and do NOT change or

modify it in any way. Modiﬁcations to

your power supply radically increases

the risk of electrocution or ﬁre, and will

immediately void your warranty.

9) LAN Port: To connect an Ethernet

cable, allowing the DVR to be connected

to a local area network. This network,

in turn, can be used to give the DVR a

connection to the Internet.

8 57 9 6

2 1

4 3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 75 76

Comments to this Manuals

No comments