Swann H.264 User Manual download pdf (Page 68)

The easiest way to access your DVR remotely is via an Internet browser. These

instructions will detail how to access the DVR via Microsoft Internet Explorer

. This

section assumes that you’ve already congured the DVR and your network to operate

properly. Remotely accessing the DVR via Internet Explorer (IE) is a great way to test

if your network is functioning as it should.

At the time of writing, the DVR supports up to

3 users accessing the DVR remotely at a time.

Note: You may have to alter and congure the ActiveX controls in IE to allow

unrestricted access to the DVR. Access might be slowed or blocked completely by

IE’s built-in security functions. The instructions on how to do this are covered on the

next page.

To access the DVR remotely via Internet Explorer:

1. Open an Internet Explorer window. If you do not have Internet Explorer you can

download it from the Microsoft website (www.microsoft.com).

2. In the address bar type “http://” followed by your public IP address, a

colon then your web port. For example, if your web port is “85” and

your public IP address is “210.9.10.115”, then you’ll need to enter the

information, shown on the image, immediately below these words

You will now see a login window. Here, enter your password. If no password is

set, leave this dialog box blank.

3. You should now have access to the DVR.

http://210.9.10.115:85

Remote Access via Internet Explorer

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 74 75 76

No comments

Swann H.264 User Manual Page 68