Swann 1060 User Manual download pdf (Page 3)

+

-

Opening the 1060 Housing

Connecting the Heater / Blower Power

3

6

Turn the 1060 housing

back to right side up and

open the top sideways to

allow access to the

camera mounting plate

fitted to the mounting rails

at the bottom of the inside

of the housing. Gently

prise the base plate up

with your hand, or use a

screwdriver if this is too

difficult.

Turn the camera on

and adjust the focus

to suit your

requirement then

close the top of the

1060 housing. Using

a “Philips Head”

screwdriver, re-

tighten the two

screws at the side of

the 1060 housing to

ensure the best

possible weather

seal.

Connect the wires you

passed through the seal

plug to the Heater /

Blower power terminals

with the positive and

negative wires as

marked in this illustration.

Once the wires are in the

screw terminal holes,

tighten the screws down

to give the wires a good

electrical connection.

Turn the 1060 Housing upside-down and then

using a “Philips Head” screwdriver, loosen the

two screws at the side of the 1060 housing until

the top of the casing can be lifted towards the

opposite side of the housing.

+ -

1 2 3 4

Comments to this Manuals

No comments