Swann ADS-450 Specifications download pdf (Page 2)

Before You Begin

FCC Verication

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio or television reception, which can be determined by turning the equipment o and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

• Connect the equipment into an outlet on a circuit dierent from that to which

the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

These devices comply with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. These devices may not cause harmful interference, and

2. These devices must accept any interference received, including interference

that may cause undesired operation.

IMPORTANT NOTE:

All jurisdictions have specic laws and regulations relating to the use of cameras. Before using any

camera for any purpose, it is the buyer’s responsibility to be aware of all applicable laws and regulations

that prohibit or limit the use of cameras and to comply with the applicable laws and regulations.

FCC Regulation (for USA): Prohibition against eavesdropping

Except for the operations of law enforcement ocers conducted under lawful authority, no person shall

use, either directly or indirectly, a device operated pursuant to the provisions of this Part for the purpose

of overhearing or recording the private conversations of others unless such use is authorized by all of the

parties engaging in the conversation.

WARNING

Modications not approved by the party responsible for compliance could void user’s authority to

operate the equipment.

IMPORTANT SAFETY INSTRUCTIONS

• Make sure product is xed correctly and stable if fastened in place

• Do not operate if wires and terminals are exposed

• Do not cover vents on the side or back of the camera and allow adequate space for ventilation

1 2 3 4 5 6 7 ... 19 20

No comments

Swann ADS-450 Specifications Page 2