Swann SR244-BVD User Manual download pdf (Page 2)

Troubleshooting Guide

Press the TALK/VIDEO

button to see camera in

silent mode

Push the CALL button

to ring bell

NOTE: If TALK/VIDEO button is held or not pushed

quickly enough video will turn off

When tone sounds the

screen will light up and

you will see the camera

image. Quickly press

the TALK/VIDEO

button to speak. Push

TALK/VIDEO button

again to turn off video

Problem: I see no image when I press the TALK/VIDEO button when someone is at the door.

Answer: Quickly push the TALK/VIDEO button and release. If you hold the TALK/VIDEO

button down too long or do not release the button quickly enough the monitor will

not show an image and remain off.

Problem: When the image comes on the screen is bright white or too dark to see who’s there.

Answer: The image is over or underexposed. Adjust the Brightness dial on the on the left side

of the Doorbell.

Problem: The unlock button for my Door Strike works occasionally or not at all.

Answer: Check the Extension Cable for damage. Ensure you are using the original cable or

replacement cable of similar quality and length. If the cable length is joined or spliced

to another cable the loss of current will prevent the Door Strike from operating

correctly.

Tip 1: Mount the camera in an obvious location where visitors can access the doorbell.

Tip 2: Test the unit is working correctly before permanently installing

TALK/VIDEO

Button

CALL

Button

Answering the Doorbell and Viewing the Camera

B&W Video Doorphone - Easy Setup Guide

www.swannsecurity.com

Swann Communications • Toll Free Technical Support: USA - 1-800-627-2799, 1-877-274-3695, Australia - 1300 13 8324 • Email: tech@swannsecurity.com

1 2

No comments

Swann SR244-BVD User Manual Page 2